EXCAVATOR OPERATION
54
IMPORTANT INFORMATION ON
EXCAVATOR OPERATION
A
Do not try to crush concrete or boulders using side
swings with the bucket. Also avoid using side sweeps
of the bucket to move earth piles.
A
Under all circumstances avoid the following
operations:
A
Excavation using the gravitational impact of the
machine.
A
Compacting of gravel or soil using the dropping
action of the bucket.
A
Excavation using the traveling power of the
machine.
A
Do not try to drop or shake off soil adhering to the
bucket in the manner given in the points below. This
can cause damage to the machine. Adhering soil can
be shaken off when the bucket is being emptied by
moving the bucket out to the maximum stroke of the
cylinder. Should this not suffice, swing out the arm as
far as possible and operate the bucket back and forth.
A
Do not hit the dozer with the boom cylinder!
Make sure that the boom cylinder does not hit the
dozer when doing deep excavation. If necessary
swing around so that the dozer is in the back of the
machine.
A
Pay attention when pulling in the bucket!
When pulling in the bucket (for driving or
transportation) avoid hitting the dozer.
A
Avoid collisions!
When moving the excavator, pay attention that the
dozer does not collide with obstructions such as
boulders etc... Such collisions shorten the life of the
dozer and the cylinder substantially.
A
Support the machine correctly!
When stabilizing the machine with the dozer, lower the
dozer to engage the full width on the ground.
A
If the water or mud level reaches higher than the top of
the tracks, the swivel bearing, swivel motor gear and
ring gear may be exposed to mud, water and other
foreign objects. The excavator must be properly
pressure washed after each use.
A
Thoroughly clean the area around the swivel
bearing, swivel motor gear and ring gear to remove
foreign objects.
A
Inspect the swivel motor oil sump (if equipped) for
water contamination. If water is present, refer to
operator's manual for lubricant replacement
procedure.
A
Refer to operator's manual for proper swivel
bearing, swivel motor gear and ring gear
lubrication procedures.
A
Reinstall any protective covering if removed
earlier.
A
Avoid applying excessive load with cylinders fully
extended, or the machine easily gets damaged.
A
When relieving the residual pressure, do it
immediately after the engine has stopped.
Summary of Contents for KX080-4
