EXCAVATOR OPERATION
54
A
If a registered black key is stolen or lost, re-register the
remaining black key. When re-registering is
performed, the stolen or lost black key is unregistered
and it becomes impossible to start the engine with that
key.
A
If the red key is stolen or lost, it becomes impossible to
register or re-register a black key (for starting the
engine) and the peripheral devices should be
replaced. Therefore store the red key with great care.
If by any chance it gets lost, promptly contact your
dealer or a Kubota-designated service factory.
A
Use the Kubota-specified key ring to hold the black key
or the red key. Any unspecified key rings may interfere
with the signal transfer between the key and the key
switch, possibly failing to start the engine or to register
a key properly.
A
Do not bundle two or more keys when using them.
Doing so may cause electric wave interference,
possibly failing to start the engine.
A
Cut and remove the ring that is used to bundle the
keys at the time of delivery. (If the keys remain
bundled, the engine may start with the red key or re-
registering could not be performed properly.)
A
If an unregistered key is inserted and turned more than
six times for one minute, the alarm sounds for 30
seconds. (The alarm keeps sounding even if the key is
drawn out.)
D
Insert and turn on the registered key, and the alarm
stops itself.
A
If something is wrong with the machine, immediately
contact your dealer and have the machine inspected
and repaired.
For Canada (FCC / IC)
A
If a black key is inserted that was previously
registered,
"Registered"
is displayed on the LCD
screen and registering will not be performed.
A
If you try to register the fifth black key,
"STOP
Register"
is displayed on the LCD screen and
registering cannot be performed.
A
In some cases, the engine may fail to get started. The
following messages appear according to the
situations.
(1) Key is being authenticated
(2) Starting with the red key
(3) Starting with the non registered key (of other
model)
FCC WARNING
A
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
A
This device complies with Part 15 of the FCC Rules
and RSS- Gen of the IC rules.
Operation is subject to the following two conditions :
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Summary of Contents for KX080-4S2
