Maintenance
113
Replacing the in-line filter
The replacement job is described using the left
control lever as example. The filter at the right
control lever is replaced similarly.
•
Take the pressure off the circuit.
•
Lift up the left control console (1).
•
Unscrew and remove the lower cover panels.
•
Disconnect the hydraulic pipe (white).
•
Remove the in-line filter (2).
•
Screw in a new filter.
•
Re-connect the hydraulic pipe.
•
Refit the cover panels.
•
Replace the in-line filter at the right control lever.
Resetting the service period indicator
The service period indicator appears after the first 50 operating hours of operation and then
every 250 hours of operation.
The service period indicator disappears after 10 seconds automatically. The following example shows a service
period indicator based on a 1500-hour interval.
When the starter switch is switched from STOP to RUN, the service period indicator shows up for the first
10 seconds, with a corresponding service message in the display.
If the working light button (boom) is pressed for more than 3 seconds, the service period indicator will reset.
Reset the service period indicator only if the service has been performed. A regular maintenance
extends the excavator's service life and assures a problem-free operation.
If the display needs to be replaced due to an error, the elapsed hours of operation are set to 0 hours by default.
In this case, please contact your authorised KUBOTA dealer.
