Operation
52
Check the oil level in the sight glass (1). The oil level should be
half way up the sight glass. Carefully check the position of the
hydraulic cylinders again before topping up. For more informa-
tion, see the "Topping up hydraulic oil" section (page 105).
Checking the water separator of the fuel system
•
A red plastic ring in the water separator (1) floats up with
the water level. If the ring is floating up, clean the water
separator (page 102).
Lubrication
•
Start the engine (page 56).
•
Position the boom, arm, bucket and dozer as shown in the
figure. Stop the engine, remove the key. See the "Operating
the controls" section (page 62).
•
Lubricate all grease points (see figure below) with grease -
see the "Recommended lubricants" section (page 116) - un-
til fresh grease emerges.
During the first 50 hours of operation, grease all grease nipples marked using "Anti-Seize"
grease.
