• Turn the headlights on. Dim the headlights when
meeting another vehicle.
• Drive at speeds that allow you to maintain control at
all times.
• Do not apply the differential lock while traveling at
road speeds. The tractor may run out of control.
• Avoid sudden motions of the steering wheel as they
can lead to a dangerous loss of stability. The risk is
especially great when the tractor is traveling at road
speeds.
• Keep the ROPS in the
“UP”
position and wear the
seat belt when driving the tractor on the road.
Otherwise, you will not be protected in the event of
a tractor roll-over.
• Do not operate an implement while the tractor is on
the road. Lock the 3-point hitch in the raised
position.
• When towing other equipment, use a safety chain
and place an SMV emblem on the equipment as
well.
(1) Safety chain
• Set the 3-point hitch lowering speed knob in the
“LOCK”
position to hold the implement in the raised
position.
(1) 3-point hitch lowering speed
knob
(A) Fast
(B) Slow
(C) Lock
PRECAUTIONS FOR PARKING
THE TRACTOR
• Disengage the PTO, lower all implements to the
ground, place all control levers in their neutral
positions, set the parking brake, stop the engine,
remove the starter key from the ignition, and lock
the cab door if equipped. Leaving transmission in
gear with the engine stopped will not prevent tractor
from rolling [HST type].
• Make sure that the tractor has come to a complete
stop before dismounting from it.
• Avoid parking on steep slopes. If it is at all possible,
park on a firm and level surface. If it is not at all
possible to park on a firm and level surface, park
across a slope and chock the wheels.
Failure to comply with this warning may allow the
tractor to move and could cause injury or death.
PRECAUTIONS FOR
OPERATING THE PTO
• Wait until all moving components have completely
stopped before getting off the tractor, connecting,
disconnecting, adjusting, cleaning, or servicing any
PTO driven equipment.
• Keep the PTO-shaft-cover in place at all times.
Replace the PTO-shaft-cap when the shaft is not in
use.
(1) PTO shaft cover
(2) PTO shaft cap
(A) Normal position
(B) Raised position
• Before installing or using PTO-driven-equipment,
read the manufacturer's manual and review the
safety labels attached to the equipment.
• When operating stationary PTO-driven-equipment,
always apply the tractor parking brake and place
chocks behind and in front of the rear wheels. Stay
clear of all rotating parts. Never step over rotating
parts.
SAFE OPERATION
L4701
11
Summary of Contents for L4701
