FRONT LOADER
LA525, LA765, WSM
1-S21
[B] LA525 (If Equipped) and LA765 (Quick Attach Type)
Bucket
1. Lower the implement to ground level with the implement slightly
in the rolled back position. Stop the engine and set the parking
brake.
2. Pull the quick attach coupler handles (1) to the unlatched
position to release the latching pins.
3. At the tractor operator's seat, start the engine and slowly move
the loader control lever to the
"DUMP"
position until the
implement is pushed away slightly from the quick attach
coupler.
4. Lower the loader boom so that the quick attach coupler
mounting plate clears the implement saddle.
5. Back away from the implement slowly.
6. If an implement is not going to the be attached to the quick
attach coupler immediately, push the handles of the quick
attach coupler to the locked position to prevent damage to the
handle assembly.
(When attaching attachments)
DANGER
To avoid serious personal injury or death:
• Use of a non-Kubota attachment that does not comply with
ISO 24410 (SAE standard of J2513) or the improper
positioning of handle(s) or non-protrusion of pin(s) may
result in detachment of the attachment or deformation,
causing loss of performance, personal injury or death.
CAUTION
To avoid personal injury or machine damage:
• Lift the boom only enough to latch the attachment.
The attachment could swing off the quick attach coupler.
DANGER
To avoid serious personal injury or death:
• The following engagement points are critical.
a) The lock pins of the quick attach coupler have to go into
and through the pin slots of the attachment on both
sides.
It is critical that the pins are in good condition and
without visible signs of wear or damage and that the
operator align the loader quick attach coupler with the
attachment to allow the pins to go through the pin slots.
b) Both handles have to be pushed down until the handles
contact the ear plates near the points where the pin bolt
goes through the handle "A".
c) Do not operate the tractor or attachment unless all of
the above conditions are made.
CAUTION
To avoid personal injury or machine damage:
• Never operate or transport attachments which are not
attached completely.
• Always replace damaged hardware immediately.
9Y1211014FLS0016US0
(1) Quick Attach Coupler Handle
(2) Quick Attach Coupler Frame
(3) Ear Plate
(4) Lock Pin
(5) Pin Slot
A: The handle contacts the ear plate
at the points.
KiSC issued 06, 2017 A
Summary of Contents for LA525
