ASSEMBLY INSTRUCTIONS
10
B
Level Indicator (Option)
1. Remove two original pins from the boom (RH).
2. Install PIN 2 and PIN 8 to the boom (RH).
A
Make sure the plate of PIN 2 is fitted in its specified
direction, as shown below.
3. Attach the level indicator.
A
Make sure the indicator assy. is attached in its
specified direction, as shown below.
4. Depending on the front attachment, loosen the level
rod lock bolt and readjust the level rod length.
A
Make sure to place the level indicator OUTSIDE hose
10 and 11 or damage to the hose will occur.
(1) Original pin
(1) PIN 2
(1) Indicator assy.
(2) PIN 8
(3) Split pin
(1) Bolt
(2) Level rod
(3) PIN 2
(4) Hose 10
(5) Hose 11
