7
ASSEMBLY INSTRUCTIONS
B
Hydraulic Line
1. Remove the cover of the hydraulic block on the tractor.
2. Install the loader hydraulic block to the tractor
hydraulic block.
Tightening torque : 23.0 N-m (2.35 kgf-m, 17.0 ft-lbs)
A
Make sure install the O-rings at the hydraulic block
cover.
A
Reuse the bolts fastening the hydraulic block cover.
3. Install the control valve assembly to the main frame
RH as shown.
4. Connect the hose from pump port on the control valve
assembly to pump port on the hydraulic block.
5. Connect the hose from tank port on the control valve
assembly to tank port on the hydraulic block.
6. Connect the hose from power beyond port on the
control valve assembly to power beyond port on the
hydraulic block.
A
Hoses pre-installed on the control valve assembly are
not securely tightened to ease installation of hoses to
hydraulic block. Be sure to securely tighten all hose
fittings after installing.
A
Turn the hose fittings so the hoses clear the tractor
and tractor parts.
(1) Hydraulic block
(A) Pump port (Orange)
(B) Power beyond port (Green)
(C) Tank port (Gray)
(1) Control valve assembly
(2) 2-M12x30 bolts
2-M12 nuts
2-M12 spring lock washers
(A) Pump port (Orange)
(B) Tank port (Gray)
(C) Power beyond port (Green)
