Kubota LA535 Operator'S Manual Download

Page: 24 / 59

develop if proper medical treatment is not
administered immediately.

• Do not move the loader control lever into the

float position when the bucket is off the ground.

To begin test operation, follow the following procedure.
1. Slightly move the control lever from the

“N”

position.

2. Slowly raise the boom of the loader just enough for

the bucket to clear the ground when fully dumped.

3. Slowly work through the dump and roll back cycles.

NOTE :

• When the control lever is at each corner

position  marked  by  asterisk  [*],  cylinder  of  the
boom and bucket work at the same time.
However,  the  lower  left  position  (raise  and  roll
back)  is  not  recommended  for  scooping
because of insufficient lift force.

IMPORTANT :

• If the boom or bucket of the loader does not

work in the directions indicated on the label,
follow the following procedure.
1. Lower the bucket to the ground.
2. Stop the engine.
3. Relieve all hydraulic pressure.
4. Recheck

and

correct

all

hydraulic

connections and oil level.

1. Four position bucket control valve

type

This  control  valve  has  two  stage  dump  positions.  The
first  dump  position  by  moving  the  lever  to  the  right
features greater speed for dumping.
The  second  dump  position  (to  further  right)  is  the
regular  dump  position.  It  has  good  power  and  control
for  dumping  precisely.  This  position  should  be  used
when  operating  another  implement  with  this  control
valve.
These two positions are separated by a detent for your
convenience.

PURGING AIR FROM THE

HYDRAULIC SYSTEM

1. Repeat operations of raising and lowering the boom

and dumping and rolling back the bucket until all the
air is removed from the hydraulic system and the
hydraulic system responds properly.

IMPORTANT :

• Do not move the loader control lever into the

float position when the bucket is off the
ground.

DUAL REMOTE HYDRAULIC

CONTROL SYSTEM

The tractor is equipped with the double-acting 2-
segment hydraulic control valve for front loader.
To apply the hydraulic power take-off for general
attachments, keep the following point in mind.

• Control lever and hydraulic hose connections.
• Loader/remote control valve lever.

1. Connecting the control lever and

the hydraulic hose

IMPORTANT :
To avoid damage to the attachments:

• Do not connect the attachments through the

hydraulic motor to the [C] and [D] ports.
If the control lever is moved to the regeneration
position (R

), the seals on the hydraulic motor

will be damaged.

• The control valve is provided with the

regeneration position (R

When the [C] and [D] ports are used to take off
the hydraulic power for the hydraulic cylinder,
be sure to connect the [C] port to the head-end
side port of the hydraulic cylinder.

• Connect the colored coupler and the hydraulic

cylinder port as the following table when using
the control valve to take off the hydraulic power
for the hydraulic cylinder.

Colored coupler

Hydraulic cylinder port

Yellow [B], Blue [C]

Head-end side

White [A], Red [D]

Rod-end side

PRE-OPERATION CHECK

PERFORMING THE TEST OPERATION OF THE LOADER

LA535