13. Checking parking brake
Pull the parking brake lever to apply the brakes. With
the key switch at
“ON”
position, the parking brake
indicator on the instrument panel lights up.
To release the brakes, push in the button at the tip of
the parking brake lever and push it forward.
NOTE :
• Make sure the
lamp on the instrument panel
goes off when parking brake lever is unlocked.
(1) Parking brake lever
(2) Release button
(A) “PARKING POSITION”
(B) “TRANSPORT POSITION”
14. Checking gauges, meter and
Easy Checker
™
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker
™
indicators.
2. Replace if broken.
15. Checking headlight, turn signal
light, hazard light, and so on
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
16. Checking seat belt and ROPS
1. Always check the condition of the seat belt
attaching hardware and ROPS before operating the
tractor.
2. Replace if damaged.
17. Checking movable parts
If any of the movable parts, such as levers and pedals,
are not moving smoothly because of rust or sticky
material, do not attempt to force them into motion.
In the above case, remove the rust or the sticky
material and apply oil or grease to the relevant spot.
Otherwise, the machine may be damaged.
INITIAL 50 HOURS
With a new machine, be sure to do the following
servicing after the first 50 operating hours.
1. Changing engine oil
(See Changing engine oil on page 117.)
2. Replacing engine oil filter
(See Replacing engine oil filter on page 118.)
EVERY 50 HOURS
1. Checking engine start system
WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
(1) Shuttle shift lever
(2) Clutch pedal
(3) PTO clutch control switch
(4) PTO gear shift lever
1.1 Preparation before testing
1. Place all control levers in the
“NEUTRAL”
position.
2. Set the parking brake, stop the engine and lower all
implements.
1.2 Testing switch for the shuttle shift lever
1. Follow the
“PARKING THE TRACTOR”
instructions.
(See PARKING THE TRACTOR on page 11.)
2. Sit on the operator's seat.
3. Shift the shuttle shift lever to the forward or reverse
position.
4. Depress the clutch pedal fully.
5. Disengage the PTO clutch control switch.
PERIODIC SERVICE
DAILY CHECK
108
M4N-071, M5N-091, M5N-111
Summary of Contents for M4N-071
