15
PTO
PTO
PTO OPERATION
To avoid personal injury:
A
Disengage PTO, stop engine, and allow all
rotating components to come to a complete
stop before connecting, disconnecting,
adjusting, or cleaning any PTO driven
equipment.
B
PTO Gear Shift Lever
To avoid personal injury:
A
Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
540E rpm positions.
Move this lever to either position with the PTO clutch
control switch or lever set to "OFF".
A
When light load, select the "540E" position for
economical operation.
B
PTO Clutch Control Lever
[Without Dual Speed model]
The PTO clutch control lever engages or disengages the
PTO clutch which gives the PTO independent control.
Shift the lever to "ON" to engage the PTO clutch. Shift the
lever to "OFF" to disengage the PTO clutch.
A
To avoid shock loads to the PTO, reduce engine
speed when engaging the PTO, then open the throttle
to the recommended speed.
A
To avoid damage of PTO clutch and implement, shift
the PTO clutch control lever slowly, when engaging
the PTO clutch. Do not keep the PTO clutch control
lever half way.
(1) PTO gear shift lever
(A) 540 rpm
(B) 540E rpm
(1) PTO clutch control lever
"ON" (Engaged)
"OFF" (Disengaged)
Summary of Contents for M6040
Page 10: ...SAFE OPERATION 6 7 DANGER WARNING AND CAUTION LABELS...
Page 11: ...7 SAFE OPERATION...
Page 12: ...SAFE OPERATION 8...
Page 13: ...9 SAFE OPERATION...
