3.1 Operating procedure for Auto Regeneration Mode
3.1.1 Regeneration operating procedure for Auto Regeneration Mode
(1) DPF switch
(2) Regeneration indicator
(3) Parked regeneration indicator
(4) Engine warning indicator
(A) Parked Regeneration side
1. The machine has been set to
“Auto Regeneration Mode”
by default.
switch lamp
“OFF”
“Auto Regeneration Mode”
is activated.
“ON”
“Inhibit Mode”
is activated.
2. When the regeneration indicator starts flashing, a specific amount of PM has built up in the DPF.
Continue to operate the wheel loader, and the regeneration process will begin automatically, make sure that you
are working in a safe area because DPF and exhaust temperature will rise.
NOTE :
• Even if the “Auto Regeneration Mode” is selected, DPF regeneration may not begin because system
requirements have not been satisfied.
• If the engine load is light, regeneration may not begin.
3. When the regeneration conditions are satisfied, the regeneration indicator stops flashing and remains constant
“ON”
.
The regeneration starts automatically whether the wheel loader is in motion or stationary.
4. When the regeneration cycle has completed, the indicator turns
“OFF”
.
NOTE :
• If you press the Inhibit side of the DPF switch during regeneration, the regeneration cycle will be
interrupted. The “Inhibit Mode” is now activated.
• During regeneration, if the engine rpm is lowered, the regeneration cycle may be interrupted.
EXHAUST AFTERTREATMENT DEVICES
OPERATION OF THE ENGINE
R540
55
Summary of Contents for R540
