5.2.2.5 Removing injection pump
(1) Notch
(2) Control rack pin
(3) Injection pump
(4) Start spring
(5) Thrust lever
(6) Governor spring
1. Disconnect the start spring (4) on the thrust lever
(5) side.
2. Align the control rack pin (2) with the notch (1) on
the crankcase, and remove the injection pump (3).
3. Remove the injection pump shims.
4. In principle, the injection pump should not be
disassembled.
(When reassembling)
NOTE
• Addition or reduction of shim delays or
advances the injection timing.
Shim (0.05 mm
(0.002 in.))
Delays or ad-
vances the in-
jection timing
Approximately
0.0087 rad
0.50°
• In disassembling and replacing, be sure to use
the same number or new gasket shims with the
same thickness.
• When installing the injection pump, insert the
control rack pin (2) firmly into the groove (7) of the
thrust lever of fork lever.
(7) Groove
SERVICING
5. Disassembling and assembling
3. ENGINE
BX1880,BX2380,BX2680,RCK60B-23BX,RCK54-23BX,RCK48-18BX,RCK60D-26BX,RCK54D-26BX
3-49
KiSC issued 03, 2019 A
Summary of Contents for ,RCK60B-23BX
