Maintenance
W9272-8135-1
189
05/2020
Oil filter - change
Place an oil pan under the oil filter (1). Remove the oil filter us-
ing a filter wrench (turn anticlockwise).
Coat the sealing ring of the new oil filter with engine oil.
Install and tighten the oil filter by hand. Do not use the filter
wrench.
Engine oil - fill
Filling capacity: 7 l
Remove the oil filler cap (2) and fill engine oil. See the "Oper-
ating materials" section (page 180).
Screw in the oil filler cap.
Start the engine (page 96). The engine oil pressure indicator
must go out as soon as the engine has started. If this does not
happen, switch the engine off immediately and contact trained
personnel.
Let the engine run at idle speed to warm up, then stop it
(page 99). Check the oil level after 5 minutes.
Pull out the oil dipstick (1) and wipe it with a clean cloth.
Insert the oil dipstick completely and pull it out again. The oil level should be in the "A" area. If the oil level is
too low, add engine oil.
When changing the engine oil, fill engine oil up to the MAX mark.
Close the engine compartment cover.
If the oil level is too high or too low, the engine might get damaged during operation.
1
1
Summary of Contents for U50-5
