6
OPERATING THE ENGINE
EN
GLIS
H
[V3300-E, V3300-TE, V3300-DI-E, V3300-DI-TE,
V3800-DI-E, V3800-DI-TE, V3300-EBG, V3300-T-EBG]
(with lamp timer in use)
A
The glow lamp goes out in about 5 seconds when
the lamp timer is up. Refer to this for pre-heating.
Even with the glow lamp off, the glow plug can be
pre-heated by turning the starter switch to the "GL
(PREHEATING)" position.
A
If the oil pressure lamp should be still on,
immediately stop the engine and check;
- if there is enough engine oil.
- if the engine oil has dirt in it.
- if the wiring is faulty.
A
If the glow lamp should redden too quickly or too
slowly, immediately ask your KUBOTA dealer to
check and repair it.
A
If the engine does not catch or start at 10 seconds
after the starter switch is set at "ST (STARTING)"
position, wait for another 30 seconds and then begin
the engine starting sequence again. Do not allow the
starter motor to run continuously for more than 20
seconds.
(1) Engine stop lever
(2) Speed Control lever
(A) "STOP"
(B) "START"
(C) "IDLING"
(D) "OPERATION"
4. Insert the key into the key switch and turn
it to the "ON (OPERATION)" position.
"OFF": SWITCHED OFF
"ON": OPERATION
"GL": PREHEATING
"ST": STARTING
5. Turn the starter switch to the "GL
(PREHEATING)" position to allow the
glow lamp to redden.
6. Turn the key to the "ST (STARTING)"
position and the engine should start.
Release the key immediately when the
engine starts.
7. Check to see that the oil pressure lamp
and charge lamp are off. If the lamps are
still on, immediately stop the engine,
and determine the cause.
(See "CHECKS DURING OPERATION" in
"OPERATING THE ENGINE" section.)
8. Warm up the engine at medium speed
without load.
