PERIODIC SERVICE
34
B
Checking and Cleaning Air Intake Screen
To avoid serious injury:
A
Be sure to stop the engine and remove the key
before cleaning.
A
Make sure that the engine is cool to the touch
before cleaning.
A
The air intake screen and air intake area must be clear
of debris to prevent the engine from overheating.
Daily or after every 5 hours of operation, check to be sure
the air intake screen and the air intake area are clean.
Dirt or chaff around the air intake screen and air intake
area or the engine cooling area decrease cooling
performance.
1. Check that the air intake screens are clear of grass
clippings and debris.
2. If screens are dirty, clean screens with a brush or
cloth.
3. Remove the dust and all foreign material from the
engine plate.
B
Checking Tire Pressure
To avoid serious injury:
A
Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A
Always maintain the correct tire pressure.
Inflation pressure in front tires rises quickly
when using compressed air.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A
Do not use tires larger than specified.
B
Inflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
(1) Air intake screen
(2) Engine plate
Tire sizes
Recommended Inflation
Max. Pressure
Front
11 x 4 - 5,
4PR Smooth
170 kPa
(1.7 kgf/cm , 25 psi)
Rear
22 x 10 - 14,
4PR Turf
110 kPa
(1.1 kgf/cm , 16 psi)
(1) Ground
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
Summary of Contents for Z121S-AU
Page 7: ......
Page 12: ... 5 SAFE OPERATION 5 DANGER WARNING AND CAUTION LABELS ...
Page 13: ...SAFE OPERATION 6 ...
Page 14: ... 7 SAFE OPERATION ...