3. When the specific gravity of electrolyte is between
1.27 and 1.29, the charging is completed.
6.2 Storing the battery
1. When storing the machine for a long period, remove
the battery from machine, adjust the electrolyte to
the proper level and store in a dry place out of
direct sunlight.
2. The battery self-discharges while it is stored.
Recharge it once a month in hot seasons and once
every 2 months in cold seasons.
7. Adjusting the throttle cable
1. Move the throttle lever to the
“FAST”
position.
(1) Throttle lever
(A) “FAST”
(B) “SLOW”
2. Link the throttle cable (1) to the speed control lever
(2) and loosely clamp the throttle cable sheath (3)
with the cable clamp bolt (A).
3. Pull up the sheath (3) of the throttle cable until the
inner wire of the throttle cable has almost no slack,
and tighten the cable clamp bolt (A).
4. Move the throttle lever to the
“SLOW”
position.
Make sure that the carburetor throttle valve is
moved smoothly.
(1) Throttle cable
(2) Speed control lever
(3) Throttle cable sheath
(A) Throttle cable clamp bolt
8. Adjusting the choke cable
1. Move the choke knob to the
“OFF”
position.
(1) Choke knob
(P) “PULL” (ON)
(Q) “PUSH” (OFF)
2. Link the choke cable (1) to the choke control lever
(2), and loosely clamp the choke cable sheath (3)
with the cable clamp bolt (A). Make sure that the
carburetor choke valve is fully opened.
3. Pull up the sheath (3) of the choke cable until the
inner wire of the choke cable has almost no slack,
and tighten the cable clamp bolt (A).
EVERY 100 HOURS
PERIODIC SERVICE
Z231KW-AU
53
Summary of Contents for Z231KW-AU
