Air cleaner components
(1) Air cleaner housing
(2) End cap
(3) Rubber vent/Ejector area
(4) Outer element
(5) Inner element
(6) Rain cap
1. Unhook retaining clips and remove end caps.
2. Check inlet screen and clean if necessary.
3. Remove and check outer element. Replace if dirty.
4. If replacing outer element, remove and check inner
element. Replace inner element if dirty.
5. Check all parts for wear, cracks, or damage, and
that ejector area is clean.
6. After checking parts, reassemble the air cleaner.
When installing the end cap, make sure the
alignment arrow on the end cap and the alignment
arrow on the air cleaner housing are aligned,
showing correct installation.
7. Reinstall end caps with ejector area down with
retaining clips.
(1) Air cleaner housing
(2) End cap
(3) Retaining clips
(4) Alignment arrow
NOTE :
• Outer element cannot be cleaned with
compressed air.
3. Checking the fuel filter
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
when attempting to make the following checks
and changes.
• Never fail to check the fuel lines periodically.
The fuel lines are subject to wear and aging.
Fuel may leak out onto the running engine,
causing a fire.
The fuel line is made of rubber and ages regardless of
service period.
1. If the fuel filter or clamps are found damaged or
deteriorated, replace them.
2. Check fuel filter. If it is clogged by debris or
contaminated with water, replace it.
3. If the dust or chaff has accumulated around the fuel
filter, remove them by hand or air blow.
IMPORTANT :
• When the fuel line is disconnected for
maintenance or repairs, close both ends of
the fuel line with a piece of clean cloth or
paper to prevent dust and dirt from entering.
• Particular care must be taken not to allow
dust and dirt to enter into the fuel pump.
Entrance
of
dust
and
dirt
causes
malfunction of the fuel pump.
(1) Fuel line
(2) Pipe clamp
(3) Fuel filter
4. Adjusting the parking brake
If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
WARNING
To avoid serious injury or death:
• Park the machine on a firm and level surface.
EVERY 100 HOURS
PERIODIC SERVICE
Z751KWi,Z781KWi,Z781KWTi
65
Summary of Contents for Z751KWi
