OPERATING THE MOWER
30
2. To set the cutting height, keep depressing the
hydraulic lift control pedal firmly to raise mower deck
to the top position. Make sure that the lift lock lever is
in unlock position. Adjust the cutting height control dial
to desired height.
3. Use the higher settings for mowing in a rough area or
when mowing tall grass. Lower settings must be used
only for smooth lawns where short grass is desired.
4. Lower the mower deck by releasing the hydraulic lift
control pedal. This lowers the mower deck from the
"TRANSPORT" position to the "OPERATING"
position.
5. Adjust the anti-scalp rollers' height as recommended
below for normal operating condition. To minimize
gouging and roller damage or wear, the anti-scalp
rollers will maintain the ground clearance of 19 mm
(0.75 in.).
A
Never allow roller to contact the ground continuously
as premature roller wear may develop if set
incorrectly.
A
Anti-scalp rollers must maintain a minimum clearance
of 6 mm (0.24 in.) to the ground.
(1) Lift lock lever
: "LOCK"
: "UNLOCK"
(1) Cutting height control dial
(2) Hydraulic lift control pedal
(1) Anti-scalp roller (Front)
(2) Anti-scalp roller (Rear)
Summary of Contents for ZD1011-AU
