OPERATING THE MACHINE
24
ENGLISH
A
The motion control linkages are adjustable.
If adjustment is required, see "ADJUSTMENT"
section. We recommend you to contact your local
KUBOTA Dealer.
C
Re-start on the slopes
To avoid serious injury or death:
A
Do not stop or change directions on the slopes.
These operations could cause loss of the
machine traction or control.
Starting procedure on the slopes is different
from the usual start mode on a flat surface,
understand how to re-start on the slopes and
use extra caution.
If a situation occurs where it is necessary to stop and re-
start on a slope, refer to the following operational steps.
How to re-start on the slopes:
1. Firmly apply parking brake (enough to prevent
movement).
2. Start the engine.
3. Set the throttle lever to the middle position.
4. Place the control levers inward to the "NEUTRAL"
position gradually.
5. Release the parking brake within about 3 seconds.
If you take more time, the engine will suddenly stop
because of a safety device. (This is to prevent the
machine from being operated with the parking brake
applied.)
When the engine stops, start over by firmly reapplying
the parking brake, and repeat steps 2 through 5 and
then 6.
6. Move the machine slowly and carefully.
FORWARD:
A
Push both motion control levers forward equally at the
same time. For travel forward in a straight line.
REVERSE:
A
Pull both motion control levers past center rearward
equally at the same time. For rearward travel in a
straight line.
GENERAL LEFT TURN:
A
Push right motion control lever further forward than the
left motion control lever. For forward travel to the left.
(1) Motion control lever
(2) Parking brake pedal
