1. Key switch
IMPORTANT :
• Because of the engine start system, the engine
may not be started except when the PTO clutch
is “DISENGAGED” (OFF), the parking brake lock
pedal is applied, motion control levers are in
“NEUTRAL LOCK” position, and the operator is
sitting in the seat.
(1) OFF
The position where the key can be inserted into or
removed from the key switch. When the key is
turned to this position, the engine shuts off.
(2) ON
The engine keeps running.
(3) PREHEAT
The glow plug is heated.
(4) START
Apply the parking brake and turn the key switch to
this position to start the engine.
STOPPING THE ENGINE
1. After idling the engine, turn the key switch to the
“OFF”
position.
2. Remove the key.
3. Do not leave the key switch
“ON”
(key in the
“ON”
position) as the battery will discharge when the
engine is not running.
4. Apply the parking brake.
1. Engine stop lever (inside the
hood)
The engine stops when the key switch is turned off.
If the engine does not stop, make sure the motion
control levers are in the
“NEUTRAL LOCK”
position,
the PTO lever is off, the mower lowered to the ground
and apply the parking brake, then carefully get off the
machine.
Then open the hood and pull engine stop lever and
hold it until the engine stops.
Then contact your local KUBOTA Dealer immediately.
WARNING
To avoid serious injury or death:
• Do not operate the machine until the engine
stop system is repaired.
(1) Engine stop lever
CHECK DURING OPERATING
IMPORTANT :
Immediately stop the engine if:
• The
engine
suddenly
slows
down
or
accelerates.
• Unusual noises suddenly occur.
• Exhaust fumes suddenly become discolored.
While operating, make the following checks to see that
all the parts are functioning normally:
(1) Easy Checker
™
1. Easy Checker
™
If the warning lamps of the Easy Checker
™
come on
during operation, immediately stop the engine, and find
the cause as shown below.
STARTING THE ENGINE
OPERATING THE ENGINE
ZD1211,ZD1221
29
