1. Seat must be all the way back before raising.
2. Pull the latch lever on the seat panel frontward.
(1) Latch lever
(A) “PULL”
3. Raise the operator's seat to the
“LOCK”
position.
(1) Operator's seat
(2) Seat support
Lowering
WARNING
To avoid serious injury or death:
• Do not drop the seat to close it.
• Watch your hands. Do not place your hands
under the seat, when closing.
1. Pull up the seat support rod and release the
“LOCK”
.
2. Lower the seat slowly to lock.
3. Slide the seat to proper position.
TILTING UP THE MACHINE
WARNING
To avoid serious injury or death:
• Park the machine on a firm and level surface.
• Set the mower deck height to 5 inch.
• Stop the engine, remove the key and engage the
parking brake.
• Be sure to chock the wheels.
• Lock the raised axle with an L-pin and snap pin
before working under the machine.
1. Lower the forward right anti-scalp roller to the
lowest position.
2. Fully open the front cover.
3. Unfold the tilt lever.
4. Keep the front cover opened.
5. Remove 2 L-pins.
6. Insert L-pins to both sides of the front axle to
position the front wheels. As shown below.
(1) Front cover
(2) Tilt lever
(3) L-pin
7. Turn the tilt lever clockwise to raise the axle to the
stop.
8. Remove the L-pin of the raised wheel and insert it
to the outside hole of the frame.
TILTING UP THE MACHINE
PERIODIC SERVICE
ZD1211,ZD1221
53
