SERVICE AS REQUIRED
1. Replacing fuses
1. Raise the operator's seat.
2. Remove the blown fuse.
3. Place a new fuse of the same capacity in position.
(1) Fuse location
(2) Slow blow fuse
IMPORTANT :
• If the new fuse happens to blow out within a
short time, contact your dealer for inspection
and repair. Never “jump” the fuse with wire or
foil, nor install a larger capacity fuse than is
recommended.
Protected circuit
Fuse
No.
Capacity (A)
Protected circuit
(1)
20 A
Engine stop
15 A
Charge system
15 A
Main system
15 A
Aux. outlet
10 A
Control system
(20 A)
(Work light)
(2)
Slow blow fuse 40 A
Check circuit against
wrong battery connection
*
Option: The fuse must be in only when the work light is attach-
ed.
2. Bleeding fuel system
Air must be removed:
1. When the fuel filter or lines are removed.
2. When tank is completely empty.
3. After the machine has not been used for a long
period of time.
Bleeding procedure is as follows:
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and
then stop the engine.
3. Checking and replacing blades
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key.
• Blades may be sharp. When you handle blades,
wear heavy gloves or wrap the end of the
blades with a rag.
NOTE :
• Before checking or replacing the blades, wipe
grass and mud off the top and inside of the
mower.
Especially, clean up inside the belt cover,
because otherwise the belt life will be reduced.
Checking
The blade cutting edges should be kept sharp at all
times. Sharpen the cutting edges if they look like blade
(B). Replace the blades if they appear similar to blade
(C).
MAINTENANCE
SERVICE AS REQUIRED
84
ZD1211,ZD1221
