ADJUSTMENT
80
ENGLISH
B
LEVEL MOWER DECK (Side-to-Side)
To avoid serious injury or death:
A
Park the machine on a firm and level surface.
A
Apply the parking brake.
A
Disengage PTO (OFF).
A
Stop the engine, remove the key and remove
the mower universal joint while checking or
adjusting the level of the mower deck.
A
Check the machine tire pressure.
Inflate tires to the correct pressure.
(See "TIRES AND WHEELS" section.)
C
Checking level (Side-to-Side)
A
Mower deck anti-scalp rollers must not contact the
ground.
[RCK60P, RCK72P]
1. Raise the mower deck to the transport position. (Also
the top end.)
2. Turn the cutting height set dial to the 3 in. cutting
height position.
3. Lower the mower deck.
4. Position the right mower blade in the Side-to-Side
position.
5. Measure from outside blade tip to the level surface
with a short ruler or leveling gauge.
Reference
A
There is a difference of the blade height between on
the concrete and ground.
6. Check that the left side blade is same height.
The difference between both measurements must be
less than 3 mm (0.12 in.).
7. If the Side-to-Side adjustment is not within the given
tolerance, adjustment is necessary.
[RCK60R, RCK72R]
1. Raise the mower deck to the transport position. (Also
the top end.)
2. Turn the cutting height set dial to the 3 in. cutting
height position.
3. Lower the mower deck.
4. Turn left blade by hand parallel to machine and turn
right blade parallel to machine to measure from the
outside blade tip at (L) and (R) to the level surface. The
difference between measurements should be less
than 3 mm (0.12 in.).
Height of the blade
at the concrete surface
76 mm (3 in.)
