PERIODIC SERVICE
50
ENGLISH
EVERY 100 HOURS
B
Cleaning Air Cleaner Primary Element
1. Remove the air cleaner cover and primary element.
2. Clean the primary element:
A
When dry dust adheres to the element, blow
compressed air from the inside, turning the
element. Pressure of compressed air must be
under 205 kPa (2.1 kgf/cm , 30 psi).
3. Replace air cleaner primary element:
Once yearly or after every sixth cleaning, whichever
comes first.
A
Check to see if the evacuator valve is blocked with
dust.
A
The air cleaner uses a dry element, never apply oil.
A
Do not run the engine with filter element removed.
A
Operating in dusty conditions requires more frequent
maintenance.
A
Align the arrow marks when reinstalling the air cleaner
cover.
A
Do not touch the secondary element except in cases
where replacing is required.
(See "Replacing Air Cleaner Primary Element and
Secondary Element" in "EVERY 1 YEAR" in
"PERIODIC SERVICE" section.)
C
Evacuator Valve
Open the evacuator valve once a week under ordinary
conditions - or daily when used in a dusty place - to get rid
of large particles of dust and dirt.
B
Checking Fuel Lines and Fuel Filter
To avoid personal injury:
A
Be sure to stop the engine and remove the key
when attempting to make the following checks
and changes.
A
Never fail to check the fuel lines periodically.
The fuel lines are subject to wear and aging.
Fuel may leak out onto the running engine,
causing a fire.
The fuel line connections should be checked annually or
every 100 service hours, whichever comes first.
1. The fuel line is made of rubber and ages regardless of
service period.
2. If the fuel line and clamps are found damaged or
deteriorated, replace them.
3. Check fuel filter, if it is clogged by debris or
contaminated with water, replace it.
A
When the fuel line is disconnected for maintenance or
repair, close both ends of the fuel line with a piece of
clean cloth or paper to prevent dust and dirt from
entering. In addition, particular care must be taken not
to admit dust and dirt into the fuel pump. Entrance of
even a small amount dust or dirt cause premature
wear and malfunction of the fuel pump and injector
components.
(1) Secondary (safety) element
(2) Primary element
(3) Cover
(4) Evacuator valve
Summary of Contents for ZD221
