71
PERIODIC SERVICE
ENGLISH
C
Protected circuit
B
Checking and Replacing Blade
To avoid personal injury:
A
Be sure to stop the engine and remove the key.
A
Blades may be sharp. When you handle blades,
wear heavy gloves or wrap end of blade with a
rag.
A
Before checking or replacing the blade, wipe grass
and mud off the top and inside of the mower.
Especially clean up the inside of the belt cover,
because otherwise the belt life will be reduced.
C
Checking
The blade cutting edges should be kept sharp at all times.
Sharpen the cutting edges, if they resemble blade (B).
Replace the blades if they appear similar to blade (C).
C
Replacing
1. Dismount the mower deck from the machine.
(See "DISMOUNTING THE MOWER DECK" in
"MOWER MOUNTING" section.)
Then turn it over to expose the blades.
2. Wedge a block of wood between the blade and mower
housing or use a box wrench over the pulley nut to
prevent the spindle from rotating while removing the
blade bolts; loosen the blade bolt as illustrated.
A
Use the proper metric size box or socket wrench to
tighten or loosen the blade mounting bolt.
FUSE NO.
CAPACITY
(A)
Protected circuit
(1)
15
Main system
15
Aux. outlet
10
Control system
20
*(Work light)
-
-
-
-
(2)
Slow blow fuse
50
Check circuit against
wrong battery connection
*Option: The fuse should be in only when the work light
is attached.
(A) New blade
(B) Worn blade
(C) Cracked blade
Summary of Contents for ZG222A
