OPERATING THE ENGINE
16
ENGLISH
B
Coolant Temperature Gauge
To avoid personal injury:
A
Do not remove radiator cap until coolant
temperature is well below its boiling point.
Then loosen cap slightly to the stop to relieve
any excess pressure before removing cap
completely.
If the indicator reaches red zone, or horn sounds
.
1. Place the PTO lever in the "DISENGAGE" (OFF)
position.
2. Move the machine to a level surface, and apply the
parking brake.
3. Place the throttle lever in the engine idle position, and
let the engine run for a few minutes.
4. Check the Cooling System, after it has sufficient time
to cool down.
Check the following items:
1. Shortage or leakage of the coolant.
2. Foreign matter on the radiator net or dust and dirt
between the radiator fins.
3. Looseness of fan belt.
4. Blockage in the radiator tube.
(See "PERIODIC SERVICE" section.)
B
Fuel Drain
To avoid personal injury:
A
Be sure to stop the engine and remove the key
when attempting to drain the fuel from the
carburetor.
A
Never fail to tighten the screw clockwise after
draining. Fuel may leak out onto the running
engine, causing a fire.
Turn the screw counterclockwise to drain the fuel from the
carburetor.
B
Fuel Pump
This fuel pump has a limit drive function.
A
When the key is in the "OFF" position: It does not work.
A
When you turn the key clockwise one notch, before the
engine starts: It works for about 15 seconds.
A
Keep the key in this position, before the engine starts.
It will stop working after 15 seconds.
And to reset the timer, keep the key in the "OFF"
position for about 60 seconds.
A
When the engine is running: It works normally.
(1) Coolant temperature gauge
(1) Screw
(2) Carburetor
Summary of Contents for ZG332
