63
PERIODIC SERVICE
ENGLISH
2. Make sure a speed control lever (2) is touching the
restricting bolt (1).
If not, loosen the rear nut (6) and tighten the front nut
(5) so that the speed control lever (2) would touch the
restricting bolt (1).
Then tighten the rear nut (6).
B
Checking Carbon Canister Air Filter
Check the carbon canister air filter every 100 hours of
operation. (more often under extremely dusty or dirty
conditions.)
To avoid personal injury:
A
Always disengage PTO, stop the engine, set
the parking brake and remove the key.
1. Remove the cover and remove the carbon canister air
filter.
2. Check to see if the carbon canister air filter is worn out,
damaged or dirty.
3. If the air filter is dirty, wash the air filter in warm water
with detergent. Then rinse the air filter thoroughly until
all traces of detergent are eliminated. Squeeze out
excess water. (do not wring.) Allow the air filter to air
dry. Do not use high pressure air to clean filter.
4. If the air filter is worn out, damaged or too dirty to wash
clean, replace it with a new one.
5. Reinstall the carbon canister air filter and secure it with
the cover.
A
Operating in dusty condition may require more
frequent maintenance than above.
(1) Restricting bolt
(2) Speed control lever
(3) Throttle cable
(4) Throttle lever
(5) Front nut
(6) Rear nut
(A) "TIGHTEN"
(1) Canister air filter
(2) Cover
(3) Carbon canister
(A) Air port
Summary of Contents for ZG332
