69
PERIODIC SERVICE
ENGLISH
B
Replacing Hydraulic Oil Filter
To avoid personal injury:
A
Be sure to stop the engine and remove the key
before changing the oil filter.
A
Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter must be changed every 400 service hours.
2. To drain the transmission oil, place oil pan underneath
the transmission case and the rear axle gear case
(RH&LH) and remove the drain plug at the bottom of
the transmission case and the rear axle gear case
(RH&LH).
3. After draining, reinstall the drain plugs.
4. Remove the oil filter by using the filter wrench.
5. Apply a slight coat of oil onto the gasket of new filter.
6. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
7. After the new filter has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
(1) Drain plug
(2) Rear axle gear case LH
(1) Oil level dipstick
(2) Oil plug and breather cup
(A) Oil level is acceptable
within this range.
(1) Oil filter
(1) Oil filter
(2) Gasket
Summary of Contents for ZG332
