K U B U W T X - 1 0 U S E R M A N U A L
3
Operation
The Kubu WTX-10 automatically comes up and begins operating once power is applied to it. No user
configuration is required.
As soon as power is applied the WTX-10 it will initialize and begin operating as an 802.11n access point with a
unique factory configured SSID. The SSID will be in the form “kubu_xxxxx” where xxxxx is a unique identifier
made up of a combination of numbers and letters (e.g kubu_abc17).
The Kubu WTX-10 will digitize the audio signal input to it via the cable plugged into the audio jack and it will
transmit that digitized audio stream over the Wifi network using the unique factory SSID.
Devices capable of receiving/playing the audio transmitted by the WTX-10 can then be connected to the Wifi
network that has unique SSID for the Kubu WTX-10 device.
Any device capable of displaying available wifi networks can be used to verify that the WTX-10 has come up and
established the wifi network since the SSID should be visible when looking for wifi networks to connect to from
a wifi enabled device such as a laptop.
FCC Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
Operation with non-approved equipment is likely to result in interference to radio and TV reception. The
user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user's authority to operate this equipment.
