FIT TOP CORNER BRACKET TO TOP RAIL
14
FIT TOP RAIL TO BOTH PANELS
15
CHECK DOOR ALIGNMENT
16
FIT SEAL TO BOTTOM OF DOOR
18
FIT VERTICAL SEAL TO IN-LINE PANEL
19
ADJUST DOOR CLOSURE (if required)
17
Loosen (do not remove) screw in rail
clamp plate and screw in top inner clamp.
Fit rail assembly so that screws locate
into the notches in each glass panel.
Slide top corner bracket FULLY into end of top rail, as shown
and fix in position using grub screw on inside.
top
inner clamp
rail for top
top corner
bracket
INSIDE VIEW
Tighten 2x screws at corner, ensuring
flange on top inner clamp is tight onto top
of side panel and corner bracket is tight
against the corner seal.
Fix rail to in-line panel using inner clamp plate and tighten
screw, ensure flange on clamp plate is to top and edge of clamp
plate lines up with edge of in-line panel.
INSIDE VIEW
flange on top
inner clamp
2x screws
fit top rail onto both
glass panels
Fit seal to bottom of door glass as shown, ensuring this is
pushed
fully
onto bottom of glass.
flexible seal
to outside
OUTSIDE
In-line panel
Door
PLAN VIEW
Fit vertical seal to edge of in-line panel as shown.
Close the door and check this
is square to the opening:
The gap between door glass
and corner seal should be
even all the way up.
The gap between bottom
edge of door glass and
bottom rail should be approx.
10mm all the way across.
Check level of tray -
front page.
Check vertical edge of In-line
panel -
stage 6.
Check rails are fully inserted
into each corner bracket -
stages 10 & 14.
If gaps are uneven re-check
the following:
!
even
gap
even
gap
10mm gap
Do not attempt to tamper with the factory-fitted hinges,
as this will invalidate the guarantee.
The closing action of the door glass against the corner closing
seal can be adjusted if this is too ‘tight’ or too ‘loose’:
Slacken (do not remove) the screws in inner clamp plates
attached to the in-line panel at top and bottom.
Move rail (and side panel) in either direction until the desired
closing action is achieved.
Re-tighten both screws when complete.
Also, check that the door closes fully against the back-stop of
the corner seal from top to bottom, if not, adjust as follows:
Remove the push-in channel from
the
side panel wallpost
by
inserting tool supplied or allen key
to pull the channel out at the top.
Adjust top of side panel glass in or
out of the wallpost to achieve full
closure of door from top to bottom
against the back-stop of corner
seal.
Re-fit the push-in channel into
wallpost.
INSIDE VIEW
wallpost for side panel
