KuDos Mechanical
Operating Instructions
1. Release the hydraulic fluid pressure
and retract the piston before the
crimping: Pull out the moving handle
and rotate it clockwise, press down the
release lever by pushing down the
moving handle to return the piston to
its starting position.
2. Place the cable and fitting into the opening of the Jaw. The cable and fitting
must be positioned at the
CENTER
of the open top to balance the
compression.
3. Follow connector specifications and apply the necessary number of crimps.
See the diagrams on page 6 for the crimping sequence.
4. Pump the moving handle back and forth to advance the piston.
5. The rapid motion of the piston with low hydraulic pressure will convert to a
slow motion with high pressure once the indentors are tightly pressed.
6. The operation will be complete when the hydraulic pressure reaches 700bar
pressure and the relief valve releases the internal pressure.
7. Repeat Step 1 to retract the piston and indentors. Repeat the compression
process according to your specifications.
OK
5
www.ptr.co.th
