-25-
V. SKIDS AND STAND (1206 910)
The EL 100 N is fitted as standard with two depth control wheels. Upon request, these
wheels can be replaced by two skids, one on each side of the machine.
Depth control is adjusted by means of 6 hole skid bar. When skids are provided as
a later alternative, assemble them following the diagram below where all parts are
shown in their respective positions.
Figure A : left skid
Figure B : right skid
A standard stand is supplied with the skids to ensure stability when machine is parked.
VI. WHEEL TRACK ERADICATORS (No 1208 000)
To eliminate tracks left by tractor wheels, a set of wheel track eradicators can be
fitted to support bar (T) without displacement brackets (S) depending upon tractor
type and tyre size. Share supports (R) can be adjusted sideways, and must be fitted
symetrically in relation to tractor tyre centreline (photo 6). A minimum span (E)
of 200 mm (8") is recommended (photo 6). The working depth of shares (P) must be
adjusted in accordance with wheel track depth. However, this must never exceed 10
cm (4"). After adjustment, do not forget to retighten the 4 bolts (V) and their lock
nuts (photo 5).
Note : Wheel track eradicators should only be used for the final pass.
Summary of Contents for EL 100 N
Page 1: ...ASSEMBLY OPERATOR S MANUAL EL 100 N POWER TILLER N 95458 A GB 12 1999...
Page 10: ...8...
Page 18: ...16...
