SERVICE MANUAL AS55X
55Xseries_manual_V3.22 (18-08-15)
www.kuhnt.com
143
7.3
Control GSM channel
Here you have the option to control the build-in GSM module by AT commands. Use the
commands of the preset list or the AT command set from the Cinterion manual. Contact
your local dealer to enable your AS55X-Service software to use this feature.
7.4
View number management
For troubleshooting/debugging, you can edit here a list of the last 30 calls. The table shows
the incoming, dialled and outgoing number of every call.
First you see if the call is initiated on the wired network or started on GSM. All calls from
GSM network are listed with the corresponding channel. Calls from the wired Network are
listed with an internal task number between 1 and 30. The listed calling numbers are for
editing how your provider or your PBX forwards the source calling number. If the AS55X
detects a special type of number (e.g. international, national), it is listed in the field “source
calling number type”. All directly routed calls are listed in the column “Source called
number”. In the “destination location / channel” you can check if the outgoing channel is
correct (e.g. if the “individual call setup” is OK?). All DTMF routed calls are listed in the next
columns. You can check if the typed number is correct. Sometimes single numbers are not
detected correctly or listed twice. Therefore you can check the “timeout DTMF recognition”
in general GSM settings (see 5.9.1). The outgoing identity is listed in “destination calling
number”, the called number is in the last column.
7.5
View call setup list
This list is to monitor the callback function of the AS55X. In the menu “global call-setup” you
can choose the call setup type. Thereafter every call or every unanswered call is shown is
this list. The last 1000 calls are saved. You can see the number from wired network and the
called mobile number. The function “delete call after callback” is also note down here.
Finally the remaining time of every call is listed. After the expiry of this time the number is
deleted from the list.
The registered numbers are managed independently from the cards. An outgoing call via
module 1 can be answered via module 2. There is only an n adjustment on the numbers.
The open list can be updated with the “Refresh” Button.
7.6
View ARP table
In the ARP table all MAC addresses are stored, which are used by the gateway. It is only a
conversion list from MAC addresses to IP addresses. Normally, only the addresses of your
PBX, of your default gateway or of your service PC should be listed here. If a MAC address is
not longer in use, it will be deleted automatically after one hour.
Summary of Contents for AS55 Series
Page 1: ...AS55X Series SERVICE MANUAL ...
Page 2: ......
Page 18: ...SERVICE MANUAL AS55X 16 www kuhnt com 55Xseries_manual_V3 22 18 08 15 ...
Page 173: ...www kuhnt com 1 Personal memo ...
