User Manual
KEA 320 / KEA 320 RP
BA-KEA 320 / KEA 320 RP_EN Version 03
Date: 16.Sep.2020
Page 13 of 21
Engines" parameter selection
The values to be displayed at "Engines" can be selected via AnalogManager
definition of the parameters at “Parameter
Configure HMI
Screen configuration”. Menu texts and symbols cannot be changed!
4
Operation
In operation the genset controller can be manually or remote controlled.
Front panel access is described in chapter 4.1 “Front Panel Access” on page 98.
Access via ToolKit is described in chapter 4.2.6 “View And Set Values In ToolKit” on page 131.
Access via Remote Panel RP 300 is described in chapter and the Technical Manual “37593 RP 300” .
Access via PLC depends on the interface and the data telegram used for communication.
For menu structure/menu tree see “Menu structure (menu tree)” on page
96.
4.1
Power ON
Behavior during starting KEA 3X0
The start-up procedure of the KEA 3X0 device can be caused by the following reasons:
Power ON
Power cycling e.g. by 1701 p. 166 “ Set factory default values”
Power is back after voltage drop
This process is visualized by the HMI of the plastic housing version or the LEDs of the metal housing version.
Using the USB Service Port
With power ON and a PC/laptop connected via USB service port it can
happen that the USB window that pops up doesn't show all files and/or the
correct available free memory at the device: Please unplug/plug the USB
connection after the KEA finished starting.
With power ON and connected USB service port it can happen that a
connected USB device is not detected correctly: Please unplug/plug the USB
connection after the KEA finished starting.
With power cycle of the KEA 3X0 the USB connection is lost: Please
unplug/plug and/or start USB connection again after the KEA finished
starting.
