User Manual
KEA 320 / KEA 320 RP
BA-KEA 320 / KEA 320 RP_EN Version 03
Date: 16.Sep.2020
Page 8 of 21
Values
[1]
The "values" section (Fig. 70/1) of the screen illustrates all measured power related information including
voltages, currents, frequencies, power, and power factor values.
If the mains data display is disabled, the main screen will only show
generator data with bigger digits.
The section's content changes based on the selected sub-menu screen. For
information on specialized menu screens refer to
Chapter 4.1.5 “Specialized Menu Screens” on page 107.
Status messages [2]
The "status message" section (Fig. 70/2) of the screen shows the actual operating information.
For a list of all operation states refer to Chapter 9.5.3 “Status Messages” on
page 984.
Alarm messages
[3]
The "alarm message" section (Fig. 70/3) of the screen shows the last alarm message that is occurred and not
yet acknowledged.
For a list of all alarm messages refer to Chapter 9.5.4.2 “Alarm Messages” on
page 988.
Single line diagram
[4]
The single line diagram (Fig. 70/4) shows the current status of the engine and power circuit breakers.
This section is also used for manual operation of the genset. For additional
information refer to Chapter 5.2.2 “Operating Mode MANUAL” on page 514.
Softkeys
[5]
The softkeys (Fig. 70/5) permit navigation between screens, levels and functions as well as configuration and
operation.
Group
Softkey
Caption
Description
Display
Display Mode
Next step to display all measured (delta/wye) voltages one after the
other.
Customer configurable screen
1 (and 2)
Change to "customer specific screen 1 (or 2)"
Notes
The name of this softbuttons is configurable, too.