OPERATING THE UNIT
Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
•
When the unit is off,if the bucket is full, the unit
beep 8 times and the Full indicator light will flas
digital display shows P2.
•
When the unit is on,if the bucket is full, the com ressor
turns off and the fan turns off after 3 minutes for
rying
the water of the condenser, then the unit will be p 8
times and the Full indicator light will flash, the di ital
display shows P2.
•
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight
0
water does not spill. Do not put the tank on the f oor
•
because the bottom of the bucket is uneven. Ot erwise
the bucket will fall and cause the water to spill.
Throwaway the water and replace the bucket.
he
bucket must be in place and securely seated f r the
dehumidifier to operate.
•
The' machine will re-start when the bucket is res ored
in its correct position.
NOTES:
• When you remove the bucket, do not touch any
arts
inside of the unit. Doing so may damage the pr duct.
•
Be sure to push the bucket gently all the way in
0
the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to op rate.
•
When you remove the bucket, if there is some
ater in
the unit you must dry it .
2. Continuous draining
Water can be automatically
emptied
into a flo
drain by attaching
the unit with a water hose(
(not included).
• Remove the water bucket from the unit and
aside.
• Lift up the side flap located on the right sid
the unit as looking from the front.(Fig.8)
•
Insert the female threaded end of the hose
through the opening.(Fig.9a)
• Screw the garden hose onto the threaded
portion
of the tray underneath
the bucket opening.
Fig.9b)
• Make sure the hose is secure so there are
0
leaks.
• Direct the hose toward the drain,making
su e that
there are no kinks that will stop the warter f owing.
• Place the end of the hose into the drain.
• Place the bucket back in the unit and make sure
that it is located correctly.(Fig.9c)
• Select the desired humidity setting and fan speed
on the unit for continuous
draining to start.
NOTE:
If the unit stops operating, check that the bucket
full light is illuminated.lf it is, remove the bucket a d empty
the contents and then check the seal between th
hose and
the drip tray.lf there is a small leak then replace t e hose
gasket and re-tignten the hose.
e
1. Pullout the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
3. Pour the water out.
Fig.?
OJ),!J
Flg.8
