3
DIRECTIONS FOR
USE OF KULLIS
DELUXE STEAMER
60
sec
Steam ready
time
10-12
min
Run time
180ml
/6oz
Water reservoir
capacity
Make sure that your steamer is not plugged in.
Fill the water reservoir to the maximum fill line. Do not over fill.
Use distilled water to avoid mineral build-up. If not possible, use normal tap water.
Note: no detergent can be added into the water reservoir or it will cause damage
and/or water spitting and/or stains on the fabric.
After filling water, place the water reservoir cap on top of the main unit and twist
counter-clockwise.
Plug the power cord into any standard outlet and turn the steamer on.
Allow approximately 60 seconds for the main unit to heat up.
Test a small area before using your steamer on your garment.
Begin using your steamer by pointing the steam outlet holes at areas you want
to steam, with an up-and-down motion, directing the steam toward the wrinkled
area.
Always hold your steamer in an upright position.
NEVER TILT FORWARD OR BACKWARD WHILE STEAMING.
Note: tilting the steamer over 45° may cause water-spitting.
The fabric should be pulled down firmly or held tightly in order to remove wrinkles.
Do not leave the steam in one spot for a long period of time. This could cause
damage to the fabric.
Turn your steamer off by sliding power switch down to the Off position.
Unplug the unit from the electrical outlet.
The unit will take approximately 5 minutes to cool down.
Once the unit has completely cooled down, empty excess water from the
reservoir and store in a cool, dry place.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18