Kulzer 05100081 Instructions For Use Manual Download

Page: 67 / 314

- 29 -

Guidance and manufacturer’s declaration – Electromagnetic immunity
Signal input / output parts port

The Translux Wave device is designed to work in the electromagnetic environment specified below.

The client or user of the Translux Wave device should always make sure that it is used only in such environment.

Phenomenon

Basic EMC standard

or test method

Immunity test levels

Electromagnetic environment – Guidance

Electrostatic

discharge (ESD)

IEC 61000-4-2

±8 kV contact

±2 kV, ±4 kV, ±8 kV,

±15 kV air

Floors must be wood, concrete or ceramic.

If the floor is lined with synthetic materials,

the relative humidity should be at least

30 %

Electrical fast

transients / bursts

b) f)

IEC 61000-4-4

±1 kV contact

100 KHz repetition frequency

The quality of the power supply should be

that of a typical commercial or hospital

environment.

Surges

Line-to-ground

IEC 61000-4-5

± 2kV

The quality of the power supply should be

that of a typical commercial or hospital

environment.

Conducted distur-

bances induce by

RF fields

b) d) g)

IEC 61000-4-6

3 V

0,15 MHz - 80 MHz

6 V

in ISM bands between

0,15 MHz and 80 MHz

80 % AM at 1 KHz

Portable or mobile RF communication

device must not be used in close proximity

of the product, including its cables, except

when these respect the distances of sepa-

ration recommended and calculated from

the equation applicable to the frequency of

the transmitter.

a)  This test applies only to output lines intended to connect directly to outdoor cables.
b) SIP/SOPS whose maximum cable length is less than 3 m in length are excluded.
c)  Testing may be performed at other modulation frequencies identified by the RISK MANAGEMENT PROCESS.
d) Calibration for current injection clamps shall be performed in a 150 Ω system.
e)  Connectors shall be tested per 8.3.2 and Table 4 of IEC 61000-4-2:2008. For insulated connector shells, perform air discharge testing to the connector

shell and the pins using the rounded tip finger of the ESD generator, with the exception that the only connector pins that are tested are those that can be

contacted or touched, under conditions of INTENDED USE, by the standard test finger shown in Figure 6 of the general standard, applied in a bent or straight

position.

f) Capacitive coupling shall be used.
g) If the frequency stepping skips over an ISM or amateur radio band, as applicable, an additional test frequency shall be used in the ISM or amateur radio

band. This applies to each ISM and amateur radio band within the specified frequency range.

h) r.m.s., before modulation is applied.
i) The ISM (industrial, scientific and medical) bands between 150 kHz and 80 MHz are 6, 765 MHz to 6,795 MHz; 13,553 MHz to 13,567 MHz; 26,957 MHz to

27,283 MHz; and 40,66 MHz to 40,70 MHz. The amateur radio bands between 0, 15 MHz and 80 MHz are 1,8 MHz to 2,0 MHz, 3,5 MHz to 4,0 MHz, 5,3 MHz

to 5,4 MHz, 7 MHz to 7,3 MHz, 10,1 MHz to 10,15 MHz, 14 MHz to 14,2 MHz, 18,07 MHz to 18,17 MHz, 21,0 MHz to 21,4 MHz, 24,89 MHz to 24,99 MHz,

28,0 MHz to 29,7 MHz and 50,0 MHz to 54,0 MHz.