Due to the form of printed models, which generally contain hollow spaces, it is necessary
to flip the model 180° with forceps to allow any trapped air to escape. As soon as the
raising liquid level has covered the model completely, flip the model so that the teeth face
down. Let the air evapurate a few seconds and then flip the model back over to its
original position. Let then cleaning clycle run normally until the pre-set time ends the
process automatically.
2 min
This second cleaning cycle is only
two minutes long.
Set the speed to “Fast”, and start
it by pressing the start button:
After the second cleaning cycle, remove the printed objects one at a time and dry them
with compressed air.
Now you can post-cure the objects as usual.
9
