Kulzer HiLite power Operating Instructions Manual Download

Page: 27 / 40

Operating instructions

HiLite

power

- 7 -

Machine description

The material to be polymerised is cured using a flash lamp in the light reflector. A filter disc reduces the radiation emitted by
the flash lamp – this radiation is not required for polymerisation. The keys and displays for setting and monitoring the machine
functions are on the control panel.

The push buttons are used to select times of 6 seconds, 90 seconds or 180 seconds. The corresponding LED ring flashes while
the unit is operated; the drawer containing the material to be polymerised is locked (not in the 6 second cycle).

At the end an acoustic signal is heard and the drawer is unlocked again. The fan which is activated automatically during
operation continues to run so that the interior of the unit is cooled down adequately.

For cleaning the light reflector and the filter disc see paragraph 9 Cleaning.

The detachable light reflector is mounted in the drawer for the polymerisation material. The prosthetic material is inserted here
with / without the object holder. There are holes in the floor of the light reflector. These are required to ensure free air circulation
to dissipate the heat generated by the flash lamp. The light reflector is designed in such a way that the light is reflected so that
it also penetrates the areas not directly illuminated.

To protect the interior of the unit against the penetration of dust and contamination, a filter is inserted into the filter drawer.

Putting the unit into operation

7.1 Transport

Transport the machine carefully in a horizontal position. Avoid jerking it!

For sizes and weight see paragraph 13 Technical Data.

7.2 Installation

The HiLite

power unit must be placed on a solid, fire-resistant surface in a way to ensure a safe horizontal position

(laboratory desk, base frames). The ambient temperature should not exceed 45°C (113°F).

Place of installation:

Table / desk with a loading capacity of at least 10 kg.

Dimensions of table / desk

(w x h x d): approx. 250 x 250 x 360 mm

CAUTION

The following instructions must be observed:

The rear panel of the machine must have a minimum distance of at least 10 cm to each wall in order not to block
the air supply for the built-in fan. There is a risk of overheating if the air required for cooling cannot circulate
freely. The service life or lamp power may be affected.

The unit must be set up in a way to ensure that the air at the bottom can be blown off freely.

7.3

Function check

CAUTION

The machine will only function properly if its components are in perfect condition.

Check the machine components thoroughly before using the machine!

Ensure that:

no machine components are damaged,

the components are free of residue and dirt,

defective parts are replaced,

the plug and the insulation of the power cord are not damaged,

the mains plug and the socket must be compatible.

7.4

Mains connection

At the rear of the unit there is a cold appliance connection (socket) with integrated mains fuses (2 pieces) and the voltage selector.

CAUTION

After setting up the unit, free access to the mains plug must be ensured in order

to unplug the unit.

To avoid damage to the unit, the voltage selector needs to be set to the correct
input voltage.
Check if the voltage selector on the rear panel has been set to the correct voltage
prior to connecting the power cord.