Kulzer HiLite power, Operating Instructions Manual

- 12 -

GB

DE

GB

FR

ES

IT

PT

NL

SE

DK

NO

FI

GR

Error

Unit condition

Cause

Elimination

Flash lamp wattage

Flash lamp warning

Light power of flash lamp decreases.  

Flash lamp should be exchanged

Flash lamp error

Insufficient light power of flash lamp.  

Polymerisation cycles (90 s and 180 s) are disabled. 

Flash lamp must be exchanged

Drawer can no  

longer be opened 

after polymerisation

Defective lift magnet

Replace lift magnet   Service

Temporary power failure

Check fuse in the cold appliance plug and,  

if required, exchange the fuse; then switch on the 

unit. Lift magnet is initialized every time the unit  

is switched on

Polymerisation  

completed in a  

normal way but 

objects are very hot

Filter disc not inserted

Insert filter disc

Defective fan

Put unit out of operation   Service.  

See also “

Fan is not running

”

Air inlet or outlet obstructed

Check environment of the unit or the interior  

structure, do not block air inlet / outlet

Interior temperature too high

Let the machine cool down, and re-start polymerisa-

tion if necessary if error occurs repeatedly   Service

Fan is not running

Time-LED ring is lit, fan 

is not activated at the 

beginning of polymerisa-

tion or does not continue 

to run at the end of 

polymerisation

Fan is wedged e.g. by components 

protruding through the holes in the 

reflector pot

Check reflector pot and clean it if required or position 

objects in a better way

Bottom of the reflector pot is bent 

and blocks the fan motor

Check reflector pot; if required, align bottom or 

replace pot

Defective fan

Replace the fan; put the unit out of operation   

Service

*

1)

 While polymerisation process is running LED indicator is blinking. When polymerisation process is finished LED indicator 

lights up permanent.

9 Cleaning

9.1 

Safety instructions

ELECTRIC SHOCK

  The flash lamp works with high voltages. If you touch the lamp, these high voltages can prove fatal.  

If moisture penetrates the machine when it is connected to the power supply, you may get an electric shock. 

Observe the following information:

Before cleaning the machine, switch it off and unplug it.

The operator must not remove the housing when servicing the machine.

CAUTION

  Cleaning and disinfection agents can cause stress cracks in the housing. 

Observe the following information:

Use mild, alcohol-based cleaning and disinfection agents.

Do not use any alkali solutions, corrosive or chafing materials, methanol, amine, technical solvents, organic compounds, 
methyl methacrylate and methyl acrylate acid methylester.

 NOTE

  Scratches or dirt in the lamp reflector, light reflector and in the filter disc reduce the efficiency of the irradiation  

and lessen the power. 

Observe the following information:

Do not scratch the machine when cleaning it.

Do not use any pointed or sharp objects for cleaning.

Remove all dirt fully, but carefully.