9
www.BormannTools.com
ENGINE OIL REPLACEMENT
1.
Place the machine on a level surface and warm up the engine for several minutes. Then
stop the engine and turn the fuel cock knob to
OFF
. Turn the fuel tank cap air vent knob
clockwise.
2.
Loosen the screw and remove the cover.
3.
Remove the oil filler cap
4.
Place an oil pan under the engine. Tilt the generator to drain the oil completely
5.
Replace the generator on a level surface.
6.
Add engine oil to the upper level.
7.
Install the oil filler cap
8.
Install the cover and tighten the screw
Recommended engine oil:
(
Technical Data
)
API Service “ SJ”
CAUTION!
Be sure no foreign material enters the crankcase.
Do not tilt the generator when adding engine oil. This could result in overfilling and damage
to the engine
Clean the oil filter every other 100hr.
AIR FILTER
Maintaining an air cleaner in proper condition is very important. Dirt induced through
improperly installed, improperly serviced, or inadequate elements damages and wears out
engines. Keep the element always clean.
1.
Remove the cover.
2.
Remove the air filter cover and element.
3.
Wash the element in solvent and dry.
4.
Oil the element and squeeze out excess oil. The element should be wet but not dripping.
5.
Insert the element into the air filter.
6.
Install the cover
CAUTION!
The engine should never run without the element; excessive piston and/or cylinder wear may result.
UPPER
LEVEL
