19
www.BormannTools.com
8. Before you start checking for throttle, shift and steering. Regularly check the fuel line.
9. Keep hands and other body parts do not touch the correct propeller and engine heat parts.
10. Aware of and comply with the relevant host country laws do not prohibit the use of time.
11. Keep abreast of the weather. In rowing query weather, to avoid the water in bad weather.
12. Tell someone you want to go where.
13. Use common sense and good judgment, boating and operate your outboard motor.
Working at a safe speed and always maintain a careful observation and other traffic obstacles.
14. Away from the swimmers keep a safe distance of 20 meters above the water and paddle to avoid machine-
generated dangerous for swimmers.
Gasoline is highly flammable and explosive gas
es.
1. Do not smoke when refueling, away from fire, flames and other sources of fire.
2. Shut down before refueling your outboard engine.
3. Use only unleaded gasoline. Use low smoke 2-stroke or 4-stroke engine oil.
4.2-stroke engine petrol and oil plus oil mixed at a ratio 25: 1.
Mixing steps:
(1) mixing the oil poured into the fuel tank. (2) will provide gasoline as fuel Mixing tube. (3) and mix
thoroughly shaken. (4) a mixture of gasoline and oil tanks in oil is added.
4-stroke engine oil and gasoline were added to set the corresponding tank.
5. Do not spill your outboard motor fuel tank. Use clean, clean, unleaded gasoline at Prepare your external fuel
mixture.
Instructions
1. Prepare the engine start
1.1 Make sure your outboard engine installed correctly and safely to your stern
Prior to use. Your outboard motor improper installation may cause harm.
1.1 (1) to the outside of your ship near your center beams as much as possible.
1.1 (2) Check your Strengthening beam clamp screw clamp screw clamp Ship evenly.
1.2 You press carburetor, fuel pump into the carburetor mixing.
1.3 choke switch (Figure 2, Figure 3) in the closed position (choke closed) (if the engine is warm, Choke switch in
position) (open choke).
1.4 In the engine running, the engine running to choke switch open
2. Start the engine
2.1 pull recoil starter handle (diagram3, Figure 4) lightly until you feel resistance.
Then pull the handle straight strong crank the engine starts. Repeat if necessary.
2.2 In your outboard motor starts idling at a low speed 3-5 minutes, and then gradually Adjustment (Figs. 1 and 4) of
the desired acceleration.
2.3 Your outboard engine is equipped with a simple idle adjustment controls, Located directly above the throttle
cable throttle cable
3. Reversed
The engine is rotated 180 degrees, in the idle position, and then to the desired acceleration.
4. Stop or turn off the engine
4.1 before closing your outer, allow the engine to return to idle the lowest two Minutes cooling, and then press the
button to stop the engine (Fig. 2, Fig. 1). Press this button
Turn the ignition current and stop the engine. 2
4.2 outboard motor when you do not use it horizontally in a cool, dry environment.
5
.Maintenance.
If you have questions about your operation or maintenance of any outside issues, please Carefully read the outboard
motor manual, Operation information and maintenance of your outboard motor
5.1 You outboard motor run-in period of four hours. Do not suddenly turn off during hard acceleration or high speed
operation during this time. Keep oil and gasoline added separately
5.3 Do not operate your engine at a constant speed does not run at full speed at this time For more than ten
minutes. Your rate fluctuations.
Summary of Contents for GM1500
Page 3: ...3 www BormannTools com ...