First step before putting in usage
!
In order to adapt your handlebar to your er-
gonomics, you should follow the additional
assembly steps:
Loosen all four previously fastened Allen
screws from the stem, when the kickboard
is in driving mode.
Only then, you can move the handlebar
to the front and back until you found the
desired position. Ongoing, you can fas-
ten the Allen screws again, to properly
mount the handlebar in this position.
Tighten them with a 4-6 Nm.
If the handlebar should not be fixed
correctly, as seen in the above illust-
ration, proceed with the adjustments
as described in the following steps:
Remove the rubber cover of the fixing
screw.
Release both 5mm Allen key screws
of the back of the porch in a counter
clockwise direction.
Handlebar assembly
(for 1950 Pure & 1950 Urban)
:
Summary of Contents for 1950 Pure
