Model A
Page 20 of 47
When choosing this button, the blade holder would move (left or right) at slow speed.
(6)
Manual left movement:
When speed set into
fast speed, if perform
, the blade holder will move
left at fast speed; if touching the left deceleration sensor, please immediately decelerate, and at
slow speed
move left
.
When speed is set into slow
, (or slow speed moving left), if touching the left end
sensor,(or loosen
manual left movement switch),then the movement would be
immediately stopped.
Please note that in auto cutting state (
), this button
is useless.
(7)
Manual right movement:
When speed set into fast
, and perform button
, the blade holder will
move right at fast speed, if touching the right deceleration sensor, then immediately decelerate,
and at slow speed
keeps moving right
.
When speed set into slow one
(or slowly moves right), if touching the right end
sensor, (or loose manual right
switch), thus the movement is stopped instantly.
Please note that in auto cutting state (
), this button
is useless.
(8)
manual blade feeding:
When perform manual blade feeding switch, the blade holder (cutting shaft) moves
forward; if loosen this button, the blade holder (cutting shaft) will move backward (leaving the
cutting shaft), if touching stop sensor, the backward movement should be stopped instantly.
※
Please note that in auto cutting state
（
）
, this button is useless.
※
When oil pressure and motor movement (clockwise) is wrong, manual blade
feeding cannot act, and now please change two phase of the 3-phase power.
(9)
Chuck on:
When perform
chuck on, the support arm rises, and chuck closely on, and tailstock
cylinder will inject support arm sleeve out.
(10)
Chuck off:
When perform
this button, the tailstock return, and chuck off, the support arm moves down.
Summary of Contents for FR-1300A
