Model A
Page 21 of 47
Please note that when motor is starting (
), this button
is useless.
(11)
Motor start:
When pressing motor start button
, the main shaft will automatically start, the main shaft
rotation direction is controlled by the control box inside rotation switch.
Please note that when chuck if OFF
, this button
is useless.
(12)
Auto roll cutting:
When pressing this auto cutting button
, the main shaft will automatically starts, two seconds
later, it will automatically perform blade feeding, if blade withdrawal touches the left end sensor,
the main shaft will stop rotating, and automatically perform chuck off
, the blade holder will
return to the original point and stay at the right side and wait for other actions.
(13)
Semi-auto cutting:
When set into semi auto cutting
, if performing the auto roll cutting
, press Chuck
on
, besides auto roll cutting and withdrawal, and can also perform auto roll cutting
from the start.
(14)
Fully-auto cutting
When set into fully auto
, if perform auto roll cutting
, press chuck on
, then it
will automatically perform roll cutting and homing movement, and stay at the right side and wait
for other actions, and now if press auto roll cutting button
, then repeat above actions.
(15)
Stop:
When performing (
), manual blade feeding ( ), motor start (
), if press stop
button
, all above actions will be stopped instantly.
When perform auto homing, press this stop button
can also stop blade holder
movement.
Summary of Contents for FR-1300A
