Bona Belt UX Manual
15
EN
Cables, extensions and plugs
Commencing Operation (Cont.)
Instructions for electrical connection (cont.)
If the machine is not connected correctly to the electricity
network, death due to electrocution may occur. To prevent
electric shocks always use a grounded three wire electrical
system. For maximum protection against electric shocks use a
circuit protected with a differential cut-out switch.
Tampering with the grounding plug in any way may result in
death from electrocution. DO NOT cut, remove or break the
grounding plug. If the socket does not match the plug consult
a qualified electrician.
Using the machine with unsuitable and/or excessively long
cables may cause injury or damage to people or objects.
Do not use the machine if the switch malfunctions.
If the machine is used with a damaged plug or power supply
cable, death may occur from electrocution. If cables or plugs
are worn or damaged in any way, have them replaced by the
manufacturer or certified machine repair center in order to
prevent risks to safety.
The machine must never be moved using its cable and the
cable must never be pulled when disconnecting from the
socket.
Keep the cable away from sources of heat, oil and sharp
edges.
Only use approved cables. The maximum recommended cable length is 10 m; for greater lengths use cables
with a larger cross-section.
MACHINE WITH 230 V~50 Hz SINGLE PHASE MOTOR 2.2 kW
For machines with a 230 V~50 Hz motor (EU), a HO5VV-F-3x2.5 mm
2
HAR-approved power supply cable must be used
along with an approved SCHUKO 2P+E 16 A 200÷250 V plug.
MACHINE WITH 230 V~50 Hz SINGLE PHASE MOTOR 3.0 kW
For machines with a 230 V~50 Hz motor (EU), a HO5VV-F-3x2.5 mm
2
HAR-approved power supply cable must be used
along with an approved 2P+E CE 32 A 200÷250 V plug.
MACHINE WITH 230 V~50 Hz SINGLE PHASE MOTOR 3.7 kW
For machines with a 230 V~50 Hz motor (EU), a HO5VV-F-3x2.5 mm
2
HAR-approved power supply cable must be used
along with an approved 2P+E CE 32 A 200÷250 V plug.
