Bona Belt UX Manual
21
EN
Starting the Machine (Cont.)
Observe the operation of
the abrasive belt. Follow the
procedures for
'Centering
the Abrasive Belt'
on page
22. The belt must run inside
the tensioning unit
(A)
and
protrude by approximately
2mm from the rubber drum
(B).
12.
13.
Close the side guard
(A).
After lowering the lever
(A),
commence sanding.
14.
Turn
the knob
from “1” to “0”
15) To stop the machine with a
single phase motor:
15.
A safety contactor is fitted to the machine. If the power fails when sanding the contactor is
activated automatically, stopping the machine from accidentally starting up when the power is
restored. To recommence sanding repeat the start-up operations described above.
