EN
Bona Edge UX
Bona Edge UX
16
17
Routine Maintenance (Cont.)
Routine Maintenance (Cont.)
If Velcro disc is worn, scrape
the disc off with a knife.
1.
Clean the steel disc with
alcohol or similar.
2.
Glue a new Velcro disc on the
steel plate.
3.
4.
Check that the disc is
centered: a disc that is
not centered may cause
unbalances and vibrations.
Replacing the Velcro disc
Remove the black stopper on the arm machine.
1.
In order to remove the screw and the tapered washer, you
need first lock the disc pulley. For this purpose to put a
screwdriver inside the arm hole.
2.
Replacing the cogged belt
Remove the metal plate disc (Turn counter-clockwise).
3.
Remove the sawdust chamber metal sheet.
Replacing the cogged belt (Cont.)
4.
5.
6.
Remove the drive belt guard metal sheet.
Remove 4 screws to divide the machine body from the
machine arm.
Remove the old cogged belt before from the motor pulley
and after from disc pulley.
7.
Fit a new cogged belt on the motor pulley and then on the disc
pulley.
8.
Reassemble all parts.
9.
